POE 1FE(802.3af) Fiber Media Converter

This series is IEEE802.3 Ethernet media converters can achieve 10 / 100Base-T twisted pair and 10 / 100Base-FX or 10,100Base-T twisted pair and 10,100Base-FX’s two kinds of media media conversion or extension of the network between the transmission distance, mainly for (20/40/60/80/120 km) long distance optical fiber transmission network. IEEE802.3af Power over Ethernet ports to provide support through a wireless access point power Category 5 Ethernet cable (AP) or IP phones and other devices.

● Automatically adapt to 10Mbps and 100Mbps environment, easy to upgrade the network;

● Device provides one Ethernet port, an Ethernet optical interface

● PSE power company for Ti chip, high stability;

● Ethernet port supports standard IEEE802.3af Power

● Power over Ethernet ports for maximum power 15.4W

● Support full and half duplex network communication, with auto-negotiation capability;

● VLAN support the transmission of long packets can support IEEE802.10 protocol products matching switches used to support up to 1916-byte Ethernet packets;

● Support UTP port cross-connect switch selection, easy to install system debugging;

● Capable of VLAN classification based PORT, this method does not affect the division of the remote device

● 1Q VLAN division, then this, the remote interface can be divided into the same VLAN

● Devices with Console port supports super terminal control device

●  Ethernet UTP Interface

Interface rate: 10/100 M, half/full duplex auto-negotiation

Interface Standard: Compatible with IEEE 802.3, IEEEE 802.1Q (VLAN)

MAC Address Capability: 4096

Connector: RJ45, support Auto-MDIX

●  Optical Ethernet interface

Wave Length: 1310nm, 1550nm

Interface rate: 100 M, half/full duplex

Interface Standard: Compatible with IEEE 802.3, IEEE 802.1Q (VLAN)

MAC Address Capability:4096

Connector: FC/SC

Fiber Transmission Distance is limited by optical circuit loss and additional loss as a result of connectors, fittings and patch panel.

Transmission distance may also be limited by fiber optic bandwidth.

●  Ethernet POE characteristics

POE standard: IEEE (port output power 15.4W)

POE type: the end of cross connection (optional for mid span)

POE port: port output power of 15.4W

POE: 1/2+, 3/6- wire line (optional for 4/5+, 7/8- line)

●  Working environment

Working temperature: -10°C ~ 50°C

Working Humidity: 5%~95 % (no condensation)

Storage temperature:    -40°C ~ 80°C

Storage Humidity: 5%~95 % (no condensation)